1-888-285-4275
Sign In
Shopping Cart
230552 2_2
- Description
- Ask a Question
- Reviews
The Capstan Winch System comes fully assembled with the Harken 40.2 ST two speed winch, including the Harken 10 inch lock-in
aluminum speed grip handle. Simply attach the assembly to the TerrAdaptor leg with the long quick release pins as described below.
Capstan Winch Bracket (P/N 230551)
The Capstan Winch Bracket is designed specifically for mounting a Harken 40 ST or 40.2 ST capstan winch. The top plate is predrilled and ready for assembly. Follow the Harken recommendations for proper mounting of
the winch to the bracket using the supplied stainless cap screws, washers and hex nuts (5 each). The screws should be torque to 6 or 7 lb/ft (DO NOT OVER TIGHTEN). The TerrAdaptor Capstan Winch Bracket employs a lightweight stainless loop that guides the rope into the capstan at the correct angle for maximum grip of the rope. The guide loop can also mind prussics which can simplify progress capture rigging.
Attaching The Winch Bracket to the TerrAdaptor System
The bracket is normally located on the rear leg of a tripod, but it can be located on any leg provided the rope or cable is safely routed. It can be attached anywhere along the smaller diameter Perf Tube. It can also be attached at the junction between the Perf Tube and larger Mid Tube by lining up the relief in the side-plates of the bracket at the junction of the two tubes. Once positioned, insert the three long quick release pins (with rings) so
that the ball detent is fully exposed on the opposite side. The bracket also has high strength auxiliary attach points at each end for rigging belays, progress capture, tie down, and other rigging needs.
Specifications
SMC Capstan Winch System
Part Number: 230552 Weight: 8.8 lbs.
- Description
- Ask a Question
- Reviews
The Capstan Winch System comes fully assembled with the Harken 40.2 ST two speed winch, including the Harken 10 inch lock-in
aluminum speed grip handle. Simply attach the assembly to the TerrAdaptor leg with the long quick release pins as described below.
Capstan Winch Bracket (P/N 230551)
The Capstan Winch Bracket is designed specifically for mounting a Harken 40 ST or 40.2 ST capstan winch. The top plate is predrilled and ready for assembly. Follow the Harken recommendations for proper mounting of
the winch to the bracket using the supplied stainless cap screws, washers and hex nuts (5 each). The screws should be torque to 6 or 7 lb/ft (DO NOT OVER TIGHTEN). The TerrAdaptor Capstan Winch Bracket employs a lightweight stainless loop that guides the rope into the capstan at the correct angle for maximum grip of the rope. The guide loop can also mind prussics which can simplify progress capture rigging.
Attaching The Winch Bracket to the TerrAdaptor System
The bracket is normally located on the rear leg of a tripod, but it can be located on any leg provided the rope or cable is safely routed. It can be attached anywhere along the smaller diameter Perf Tube. It can also be attached at the junction between the Perf Tube and larger Mid Tube by lining up the relief in the side-plates of the bracket at the junction of the two tubes. Once positioned, insert the three long quick release pins (with rings) so
that the ball detent is fully exposed on the opposite side. The bracket also has high strength auxiliary attach points at each end for rigging belays, progress capture, tie down, and other rigging needs.
